Omega Resonator

How to use openEMS. Discussion on examples, tutorials etc

Moderator: thorsten

Post Reply
spflanze
Posts: 1
Joined: Wed 23 Mar 2022, 23:10

Omega Resonator

Post by spflanze » Wed 23 Mar 2022, 23:45

Attached is an image of a microstrip Omega Resonator. An edge launch SMA connector will be attached to their footprints on the left, and right, edges of this board. The microwaves will be fed from the left, and a 50 ohm impedance matching load attached to the right.

The task is to simulate the frequency response, and find the resonant frequency. Can openEMS simulate a curved shape as shown in the center of this board, and do this task?
Omega Resonator 0.8 mm PCB.png
Omega Resonator 0.8 mm PCB.png (610.77 KiB) Viewed 1252 times

Post Reply