Simple stripline with lumped port

How to use openEMS. Discussion on examples, tutorials etc

Moderator: thorsten

Post Reply
Gordon
Posts: 7
Joined: Wed 04 Aug 2021, 12:52

Simple stripline with lumped port

Post by Gordon » Fri 29 Oct 2021, 13:57

I tried some simple stripline simulation with two ports but I don't get the expected results. S11 should be much lower and S21 should be near 0 for a substrate of 0.254mm height and a stripline width of 0.53mm.
Attachments
StriplineTest.m
Simulation
(2.48 KiB) Downloaded 373 times
Result.png
Result
Result.png (21.79 KiB) Viewed 2686 times

Post Reply